About the inspection of easy loose parts before the aluminum plate cutting machine is turned on
【Case summary】:Mintech Electronics reminds you to check some loose parts before starting the aluminum plate cutting machine , such as: |
Mintech Electronics reminds you to check some loose parts before starting the aluminum plate cutting machine , such as:
(1) Whether the pulley is loose, deformed, too loose or too tight;
(2) The amount of hydraulic oil is best to be kept at 70% full, if not enough, it can be added in an appropriate amount;
(3) Regularly add lubricating oil to some special parts of the aluminum plate cutting machine, such as bearing steel;
(4) Check the amount of aluminum alloy cutting fluid in the micro-lubrication device and whether there is aluminum chip blockage in the metering room, replace and clean in time; adjust the amount of dripping per minute according to the working conditions, and the filter element of the gas-water separator It should be cleaned once every three months, and pay attention to observe that the water storage cup should automatically drain normally.
Mintech Electronics specializes in R&D, manufacturing and sales of aluminum plate cutting machines, aluminum plate engraving machines , CNC machining centers, etc., suitable for cutting and engraving aluminum plates, copper plates, composite plates, engineering plastics, etc. Welcome to consult.